GUIDES · METAL SPINNING
Metal spinning guides and tools
Our guides on metal spinning and CNC spinning programming, the metal spinning glossary and a free calculator, in one place. The content is based on general, textbook-level knowledge and is written as a starting point for decisions in the workshop.
Last updated: · KSOTech Engineering Solutions
If you are new to metal spinning, start with the glossary: it gives short definitions of the blank, mandrel, roller, pass, spinning ratio and other terms. The programming guide then explains step by step how a program for a CNC spinning lathe is prepared, from the blank diameter to pass design and G-code structure.
If you are choosing between conventional and shear spinning, the comparison guide explains the differences in blank diameter, wall thickness and the sine law with worked examples. If you are deciding how to program your lathe, the teach-in vs CAM guide sets teach-in, hand-written G-code and offline programming side by side in a decision matrix. The blank size calculator gives a first estimate for cups, cones and hemispheres in your browser. To take that preparation from a DXF profile to a pass plan and G-code, have a look at the metal spinning CAM page.
The guides are linked to each other: the key concepts of the programming guide have short entries in the glossary, and the comparison guide points to the calculator for the blank and to the programming guide for pass design. Each page shows its last-updated date, which changes only when the content does. New guides are listed here as they are added.
Numbers and examples in the guides are illustrative; real values depend on material, machine and tooling. Validate every new part with a trial run.
Guides and tools
- GuideMetal spinning programming guideThe basics of programming a CNC spinning lathe: blank diameter, spinning ratio, pass design, G-code structure and common defects.→
- GlossaryMetal spinning glossaryShort definitions of blank, mandrel, roller, pass, shear spinning, the sine law and more.→
- GuideShear spinning vs conventional spinningComparison table, the sine law with a worked example, blank diameter for each method and how flow forming differs.→
- GuideTeach-in vs hand-written G-code vs CAMThree ways to program a CNC spinning lathe: strengths, limits, a decision matrix and a checklist for moving from teach-in to CAM.→
- ToolBlank size calculatorFree blank diameter estimate for cups, cones, hemispheres or a known area, with trim allowance and mm/inch.→
- ProductMetal spinning CAM softwarePass planning from a DXF profile, shear regions, back passes, toolpath simulation and machine-ready G-code, in the browser.→